Edwards nXDS Dry Scroll Vacuum Pump Tip Seal Kit, For Minor Rebuild Service, Fits All nXDS Series Pumps, PN: A735-01-801

These Edwards nXDS series dry scroll pump tip seal kits are used when a minor rebuild service is required. This is typically needed 2-years after the pump is placed into service, often required between 12,000 and 16,000 operating hours. The pump will start to lose its ability to reach the lowest ultimate pressure as the tip seals become worn out. The base pressure for a new nXDS pump is often measured at 10 mTorr or less when evacating a good clean leak-tight vacuum chamber. If you notice that your base presure is now only getting to 25 mTorr then the tip seal will likely need to be replaced. Please see the instructions shown in the tip seal replacement manual in our Downloads section below.

Works With All Edwards nXDs Series Dry Scroll Vacuum Pumps

• Edwards nXDS6i
• Edwards nXDS10i
• Edwards nXDS15i
• Edwards nXDS20i
• Edwards nXDS6ic
• Edwards nXDS10ic
• Edwards nXDS15ic
• Edwards nXDS20ic
• Edwards nXDS6ir
• Edwards nXDS10ir
• Edwards nXDS15ir
• Edwards nXDS20ir